Special Repair Requirement

INSPECTION AND ADJUSTMENT


MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Special Repair Requirement

1.START
With CONSULT-III
1. Activate "INSPECTION MODE 1" ( Mode 1) to start engine, and warm up engine to normal operating temperature.
2. Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT-III.
3. Clear mixture ratio self-learning value by touching "CLEAR".
With GST
1. Activate "INSPECTION MODE 1" ( Mode 1) to start engine, and warm up engine to normal operating temperature.
2. Turn ignition switch OFF.
3. Disconnect mass air flow sensor harness connector.
4. Turn ignition switch ON (READY).
5. Depress the accelerator pedal to start engine, then keep engine running for at least 5 seconds.
6. Turn ignition switch OFF and reconnect mass air flow sensor harness connector.
7. Select Service $03 with GST. Make sure DTC P0102 is detected.
8. Select Service $04 with GST to erase the DTC P0102.
- END