Body Control System

BCM (BODY CONTROL MODULE)


Removal and Installation


REMOVAL

CAUTION:
Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Special Repair Requirement.
1. Disconnect the 12-volt battery negative terminal.
2. Remove the combination meter. Removal And Installation.





3. Remove the BCM screws (A) using a suitable tool, and pull out the BCM (1).
4. Disconnect the BCM connector and remove the BCM (1).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- When replacing BCM, perform "WRITE CONFIGURATION". Description Special Repair Requirement.
- When replacing BCM, perform the system initialization (NATS). Refer to the CONSULT-III operation manual for the initialization procedure.
- When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered. Refer to the CONSULT-III operation manual for the initialization procedure.