Spoiler: Service and Repair

REAR SPOILER


Removal and Installation












Removal
1. Remove trunk lid finisher (if equipped). Refer to Coupe.
2. Disconnect high mounted stop lamp connector.
3. Using a suitable tool, pry foam tape free from trunk lid surface.

CAUTION:
Use care not to damage painted surfaces during removal of, or releasing adhesive backed foam tapes.
4. Release the high mounted stop lamp harness grommet from trunk lid, then remove rear spoiler.

Installation
Installation is in the reverse order of removal.

NOTE:
- Before installing rear spoiler, clean the surface where it will be mounted with isopropyl alcohol or equivalent to degrease the surface.
- Before installing, be sure there are no gaps or waves in the foam tape where the surfaces meet.
- During installation, be sure grommet of high mounted stop lamp harness is fully seated into trunk lid opening prior to final rear air spoiler placement.