Removal And Installation

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)


Removal and Installation


CAUTION:
Be careful of the following.
- Before servicing, disconnect the battery cable from negative terminal.
- To remove brake pipe, use a suitable tool (flare nut wrench) to prevent flare nuts and brake tube from being damaged. To install, use suitable tool (flare nut torque wrench).
- Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Do not remove and install ABS actuator and electric unit (control unit) by holding harness.
- After work is completed, bleed air from brake tube. Refer to Service and Repair.
- After installing harness connector on the ABS actuator and electric unit (control unit), make sure connector is securely locked.

REMOVAL
1. Remove front wiper arms. Refer to Removal and Installation.
2. Remove cowl top. Refer to Coupe.
3. Disconnect washer hose.
4. Disconnect the battery negative terminal.
5. Remove tower bar, if equipped. Refer to Exploded View.
6. Disconnect ABS actuator and electric unit (control unit) connector.
7. Loosen brake tube flare nuts, then remove brake tubes from ABS actuator and electric unit (control unit) using a suitable tool.
8. Remove ABS actuator and electric unit (control unit) nuts.
9. Remove ABS actuator and electric unit (control unit).
10. Remove bracket as necessary.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
In the case that the ABS actuator and electronic unit (control unit) is replaced, after installation, adjust position of steering angle sensor. Refer to Special Repair Requirement.