Removal and Installation LH

ROCKER COVER


Removal and Installation LH


REMOVAL
1. Remove the engine room cover.
2. Remove front air duct. Refer to Service and Repair.
3. Remove blow by hose from rocker cover.





4. Remove camshaft position sensor.

CAUTION:
- Handle carefully to avoid dropping and shocks.
- Do not disassemble.
- Do not allow metal powder to adhere to magnetic part at sensor tip (A).
- Do not place sensors in a location where they are exposed to magnetism.
5. Disconnect the ignition coil connectors.
6. Remove the ignition coils. Refer to Removal and Installation LH.

CAUTION:
Never shock ignition coils.





7. Remove LH rocker cover bolts from cylinder head as shown.

Arrow Indicates Front

INSTALLATION
Installation is in the reverse order of removal.





- Apply sealant to the areas on the front corners using Tool.
- Use Genuine Silicone RTV Sealant or equivalent. Refer to Fluid Type Specifications.

Tool number : WS39930000 ( - )






- Tighten the rocker cover bolts in two steps in the order as shown.

Arrow Indicates Front