Component Inspection

ELECTRONIC CONTROLLED ENGINE MOUNT


Component Inspection

1.CHECK ELECTRONIC CONTROLLED ENGINE MOUNT CONTROL SOLENOID VALVE
With CONSULT-III
1. Turn ignition switch OFF.
2. Reconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
4. Turn ignition switch ON.
5. Select "ENGINE MOUNTING" in "ACTIVE TEST" mode with CONSULT-III.





6. Check air passage continuity and operation delay time under the following conditions.





Without CONSULT-III
1. Turn ignition switch OFF.
2. Disconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.





4. Check air passage continuity and operation delay time under the following conditions.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace electronic controlled engine mount control solenoid valve.