Removal And Installation

FRONT SEAT BELT


Removal and Installation


REMOVAL OF SEAT BELT RETRACTOR - COUPE

CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
1. Disconnect both negative and positive battery terminals, then wait at least three minutes.
2. Remove the rear seat cushion and seat back. Refer to Coupe.
3. Remove door welt and kicking plate. Refer to Coupe.
4. Release the pawl and remove anchor bolt cover, then remove lower anchor bolt.
5. Release the D-ring anchor bolt cover, then remove D-ring anchor bolt from center pillar.
6. Remove rear lower finisher. Refer to Coupe.





7. Disconnect seat belt pretensioner connector (1).
Arrow Indicates Vehicle front

CAUTION:
- For installing/removing seat belt pretensioner connector, insert a thin screwdriver wrapped with tape into the notch; lift locking tab then remove connector.
- Install connector with lock raised, then push locking tab into connector.
8. Remove seat belt retractor screw (A) and retractor anchor bolt
(B), then remove seat belt retractor (2) from center pillar.

INSTALLATION OF SEAT BELT RETRACTOR - COUPE
Installation is in the reverse order of removal.
- Always perform an inspection after repair to be sure the system is functioning within specifications. Refer to Procedures.

REMOVAL OF SEAT BELT RETRACTOR - SEDAN

CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
1. Disconnect both negative and positive battery terminals, then wait at least three minutes.
2. Release the pawl, then remove outer anchor bolt cover and outer anchor bolt.
3. Remove front and rear door welts and kicking plates. Refer to Coupe.
4. Remove center pillar lower finishers. Refer to Sedan.
5. Remove D-ring anchor bolt from seat belt adjuster.
6. Remove seat belt retractor.





- Disconnect the seat belt pretensioner connector.

CAUTION:
- For installing/removing seat belt pretensioner connector, insert a thin screwdriver wrapped with tape into the notch; lift locking tab then remove connector.
- Install connector with lock raised, then push locking tab into connector.
- Remove screw and retractor anchor bolt, then remove seat belt retractor from center pillar.

INSTALLATION OF SEAT BELT RETRACTOR- SEDAN
Installation is in the reverse order of removal.
- Always perform an inspection after repair to be sure the system is functioning within specifications. Refer to Procedures.

REMOVAL OF SEAT BELT BUCKLE

CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
2. Remove the front seat from the vehicle. Refer to Coupe.





3. Remove anchor nut (A) from the seat belt buckle (1).
4. Disconnect the seat belt buckle harness connector (2), release the harness clip(s), then remove the seat belt buckle (1).

INSTALLATION OF SEAT BELT BUCKLE
Installation is in the reverse order of removal.
- Always perform an inspection after repair to be sure the system is functioning within specifications. Refer to Procedures.