Removal And Installation

HEADLINING


Removal and Installation


REMOVAL
1. Remove front body side welt (LH/RH) and rear body side welt (LH/RH). Removal And Installation.
2. Remove front pillar garnish (LH/RH). Removal And Installation.





3. Disconnect microphone harness connector (A).
4. Remove center pillar upper garnish (LH/RH). Removal And Installation.
5. Remove luggage side upper finisher (LH/RH). Removal And Installation.
6. Remove sunvisor assembly mounting screws, and then remove sunvisor assembly (LH/RH).
7. Remove inside mirror cover and then remove inside mirror. Removal And Installation.
8. Disengage room lamp lens fixing pawls with a remover tool, the mounting screws and then remove the room lamp. Removal And Installation.






Broken Triangle : Pawl

9. Disengage the map lamp fixing pawls with a remover tool and then remove the map lamp.






Broken Triangle : Pawl


10. Remove the assist grips.
- Insert a small minus driver as shown by the arrow in the figure to disengage the fixing pawls.
- Remove the mounting bolts.
- Pull out the assist grip to remove.






Broken Triangle : Pawl

11. Rotate the sunvisor holder (LH/RH) at approximately 90 degrees and then pull it down to remove.
12. Remove the headlining clip located at the rear side with a remover tool.





13. Remove the headlining assembly through the back door.

CAUTION:
- When removing headlining, 2 workers are required. (1 for the front and rear of headlining)
- Cover center console finisher upper surface with a shop cloth to prevent it from being damaged.
- Never bend headlining when removing.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Never bend headlining when installing.
- When installing, start by installing both sunvisor holders and headlining clips in order to keep the headlining in position.