Removal And Installation
BODY SIDE TRIM
Removal and Installation
CAUTION:
- Wrap the tips of flat-bladed screwdriver with a shop cloth before removing metal clips from garnishes.
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.
REMOVAL
FRONT PILLAR GARNISH
1. Release front pillar portion of body side welt.
2. Remove front pillar garnish.
- Insert a remover tool between front pillar garnish and body panel.
- Disengage metal clip, clip and pawls.
- Pull out front pillar garnish to remove.
FRONT KICKING PLATE INNER
Broken Triangle : Pawl
1. Pull up front kicking plate to disengage the pawls.
2. Remove front kicking plate from the body panel.
DASH SIDE FINISHER
1. Remove front kicking plate inner.
2. Disengage dash side finisher fixing clip and pawl with remover tool.
3. Pull back dash side finisher to remove it from metal clip.
NOTE:
The metal clip remain on the body side after removal of dash side finisher.
REAR KICKING PLATE INNER
Broken Triangle : Pawl
Disengage rear dash side finisher fixing pawls and remove it.
FRONT BODY SIDE WELT
1. Remove front kicking plate inner.
2. Remove dash side finisher.
3. Remove front body side welt from panel flange.
REAR BODY SIDE WELT
1. Remove rear kicking plate inner.
2. Remove rear body side welt from panel flange.
CENTER PILLAR LOWER GARNISH
1. Remove front kicking plate inner.
2. Remove rear kicking plate inner.
3. Remove front and rear body side welt.
4. Remove front seatbelt floor anchor bolts (LH/RH). Removal And Installation.
5. Pull center pillar lower garnish crosswise to disengage the fixing pawls as shown in the figure by the arrow 1.
6. Pull back center pillar lower garnish to disengage the fixing metal clips.
7. Remove center pillar lower garnish from body panel.
CENTER PILLAR UPPER GARNISH
1. Remove center pillar lower garnish.
2. Remove front seatbelt shoulder anchor bolt. Exploded View.
3. Remove front and rear body side welt.
4. Remove the bolt cover and the bolt behind that cover.
5. Pull up center pillar upper garnish to remove.
INSTALLATION
CAUTION:
When installing, check that clips, pawls and metal clips are securely fitted in panel holes on body, and then press them in.