Control Arm: Testing and Inspection

TRANSVERSE LINK


Inspection


INSPECTION AFTER REMOVAL

Transverse Link
Check the following items, and replace the part it necessary.
- Transverse link and bushing for deformation, cracks or damage.
- Ball joint boot for cracks or other damage, and also for grease leakage.

Swing Torque
1. Manually move ball stud to confirm it moves smoothly with no binding.
2. Move ball stud at least ten times by hand to check for smooth movement.





3. Hook a spring balance (A) at cutout on ball stud (B). Confirm spring balance measurement value is within specifications when ball stud begins moving.





- If swing torque exceeds standard range, replace transverse link assembly.

Axial End Play
1. Move ball stud at least ten times by hand to check for smooth movement.
2. Move tip of ball stud in axial direction to check for looseness.

Axial end play : Specifications

- If axial end play exceeds the standard value, replace transverse link assembly.

INSPECTION AFTER INSTALLATION
1. Check wheel sensor harness for proper connector. Exploded View.
2. Check wheel alignment. Front Suspension.
3. Adjust neutral position of steering angle sensor. Special Repair Requirement.