Removal And Installation

CVT SHIFT SELECTOR


Removal and Installation


REMOVAL

CAUTION:
Make sure that parking brake is applied before removal and installation.
1. Disconnect the battery cable from the negative terminal. Removal And Installation.
2. Shift selector lever knob in "N" position.
3. Slide knob cover downward.

CAUTION:
Be careful not to damage selector lever knob.
4. Pull out lock pin from selector lever knob.
5. Remove selector lever knob and knob cover as a set from selector lever.

CAUTION:
Never press selector button.
6. Remove center console assembly. Exploded View.
7. Disconnect CVT shift selector connector.
8. Disconnect key interlock cable from CVT shift selector assembly. Exploded View.(Without intelligent Key system)
9. Remove the bolts from the CVT shift selector assembly.
10. Remove exhaust front tube, center muffler and heat plates. Exploded View.
11. Remove the plate from the CVT shift selector assembly.
12. Remove the lock plate from the control cable. Exploded View.
13. Remove control cable from the CVT shift selector assembly. Exploded View.





14. Insert flat-bladed screwdrivers at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the CVT shift selector assembly to remove the CVT shift selector assembly from the underside of the vehicle.

Arrow Indicates : Vehicle front

15. Remove CVT shift selector assembly from vehicle.

INSTALLATION
Note the following, and install in the reverse order of removal.





- When installing control cable (1) to CVT shift selector assembly (2), check that control cable is fully pressed in with the ribbed (A) surface facing upward.

Arrow Indicates : Vehicle front





- Refer to the followings when installing the selector lever knob to the CVT shift selector assembly.
- Install the lock pin (1) to the selector lever knob (2).
- Install the knob cover (3) to the selector lever knob.
- Shift selector lever in "N" position.
- Insert the shift lever knob into the shift lever until it clicks.

CAUTION:
- Install it straight, and never tap or apply any shock to install it.
- Never press selector button.