Initial Inspection and Diagnostic Overview

LINE PRESSURE TEST


Inspection and Judgment


INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary. Inspection.
2. After engine warms up, drive the vehicle in an urban area for approximately 10 minutes.

NOTE:
When ambient temperature is 20�C (68�F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80�C (122 to 176�F).
3. Inspect the amount of CVT fluid. Replenish if necessary.





4. Remove oil pressure detection plug (A).
5. Install oil pressure gauge [special service tool: -- (OTC3492)].

NOTE:
When using oil pressure gauge, be sure to use O-ring attached to oil pressure detection plug.
6. Securely engage parking brake so that the tires do not turn.
7. Start the engine.
8. Measure the line pressure at both idle and the stall speed.

CAUTION:
Keep brake pedal pressed all the way down during measurement.

Line pressure : Line Pressure

9. Install O-rig to oil pressure detection plug.

CAUTION:
- Never reuse O-ring.
- Apply CVT fluid to O-ring.
10. Install oil pressure detection plug.

Torque : 7.5 N.m (0.77 kg-m, 66 in-lb)

JUDGMENT