Removal And Installation

FRONT BUMPER


Removal and Installation


REMOVAL
1. Release the core support cover clips, then remove the core support cover.
2. Release the engine under cover clips, then remove engine under cover.
3. Remove the front fender protector side covers RH/LH. Removal And Installation.
4. Remove the front fender protector clips and screws from the front edge and partially remove, pulling them away for access.
5. Remove the front bumper fascia clips and screws, then remove front bumper fascia.
6. Remove the fog lamps if equipped. Xenon Type.
7. Remove the front grille. Service and Repair.
8. Remove the front energy absorbing foam.
9. Disconnect the harness connector, then remove the ambient temperature sensor.
10. Remove the upper fascia support bolts, then remove upper fascia support.
11. Remove the front bumper reinforcement bolts, then remove front bumper reinforcement.
12. Remove the front bumper stay bolts, then remove the RH/LH front bumper stays.

INSTALLATION
Installation is in the reverse order of removal.