Sunshade Motor Assembly

SUNSHADE MOTOR ASSEMBLY


Removal and Installation


REMOVAL

CAUTION:
- Before removing sunshade motor, check that glass lid is fully closed.
- After removing sunshade motor, do not attempt to rotate sunshade motor assembly as a single unit.
1. Close glass lid.
2. Remove the headlining. Removal And Installation.





3. Disconnect sunshade motor assembly harness connector (A).
4. Remove sunroof motor assembly screws (B), then remove sunroof motor assembly (1) from sunroof unit assembly frame.

INSTALLATION

CAUTION:
Before installing the sunshade motor assembly, be sure to the place the link and wire assembly in the symmetrical and fully closed position.
1. Move the sunshade motor assembly laterally so that the gear is completely engaged into the wire on the sunroof unit assembly frame, and mounting surface becomes parallel.
2. Install and tighten sunshade motor assembly screws.
3. Connect the sunshade motor assembly harness connector.
4. Install the headlining. Removal And Installation.
5. Perform initialization procedure. With Dual Panel Sunroof.