CAN

ECM BRANCH LINE CIRCUIT


Diagnosis Procedure

Regarding Wiring Diagram information, Electrical Diagrams.
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
- Models without automatic drive positioner
- ECM
- Harness connector E30
- Harness connector M1
- Models with automatic drive positioner
- ECM
- Harness connector E29
- Harness connector B10
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of ECM.
2. Check the resistance between the ECM harness connector terminals.





Is the measurement value within the specification?
YES - GO TO 3.
NO - Repair the ECM branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the ECM. Power Supply And Ground Circuit.
Is the inspection result normal?
YES (Present error)-Replace the ECM. Description Special Repair Requirement.
YES (Past error)-Error was detected in the ECM branch line.
NO - Repair the power supply and the ground circuit.