Removal And Installation
IGNITION COIL, SPARK PLUG AND ROCKER COVER
Removal and Installation
REMOVAL
1. Remove intake manifold. Component.
2. Remove ignition coil.
CAUTION:
- Handle it carefully and avoid impacts.
- Never disassemble.
3. Remove spark plug using suitable tool.
CAUTION:
Never drop or shock it.
4. Remove rocker cover.
- Loosen bolts in reverse order as shown.
Arrow Indicates Engine front
INSPECTION AFTER REMOVAL
CAUTION:
- Never drop or shock spark plug.
- Checking and adjusting spark plug gap is not required between change intervals.
- If spark plug tip is covered with carbon, a spark plug cleaner may be used.
- Never use wire brush for cleaning spark plug.
INSTALLATION
1. Install rocker cover gasket to rocker cover.
2. Install rocker cover.
- Tighten bolts in two steps separately in numerical order as shown.
Arrow Indicates Engine front
CAUTION:
Check if rocker cover gasket is not dropped from the installation groove of rocker cover.
3. Install spark plug using suitable tool.
CAUTION:
Never drop or shock it.
4. Install ignition coil.
CAUTION:
- Handle it carefully and avoid impacts.
- Never disassemble.
5. Install intake manifold. Component.