Removal And Installation

CONTROL LINKAGE


Removal and Installation


REMOVAL
1. Remove battery. Removal and Replacement.
2. Remove air cleaner and air duct. Removal And Installation.





3. Remove shift cable from shift lever as shown.





4. Remove select cable from select lever as shown.
5. Shift control lever to neutral position.
6. Remove control lever handle.
7. Remove center console assembly. Removal And Installation.
8. Remove control device assembly nuts.
9. Remove exhaust front tube, center muffler and heat shield. Removal And Installation.
10. Remove cable support bracket.
11. Remove select cable and shift cable from cable bracket.
12. Remove control device assembly from the vehicle.

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
Tapping work for tapping bolt is not applied to new clutch housing. Do not perform tapping by other than screwing tapping bolt because tapping is formed by screwing tapping bolt into clutch housing.
- Securely install each cable to shift lever and select lever.





- Be careful about the installation direction, and screw control lever handle onto control lever.
<-- : Front
- When control lever is selected to 1st-2nd side and 5th-6th side, confirm control lever returns to neutral position smoothly.
- When control lever is shifted to each position, make sure there is no binding or disconnection in each boot.