Removal and Installation

FRONT DOOR GLASS AND REGULATOR


Removal and Installation












DOOR GLASS

Removal
1. Remove the front door finisher. Service and Repair.
2. Disconnect the front door speaker electrical connector.
3. Position aside the vapor barrier.





4. If equipped, reconnect the power window switch electrical connector. Operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
5. Remove the door glass bolts.





6. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the inside of the door.
7. Remove the door glass run from the door panel.

Installation
Installation is in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1. Remove the front door finisher. Service and Repair.
2. Disconnect the front door speaker electrical connector.
3. Position aside the vapor barrier.





4. If equipped, reconnect the power window switch connector.
Operate the power window main switch to raise/lower the door window until the door glass bolts can be seen.
5. Remove the door glass bolts.





6. Raise the door glass and hold with a suction lifter (A).
7. If equipped, disconnect the power window switch connector from the regulator assembly.
8. Remove the regulator bolts and regulator assembly.





- If equipped remove bolt (A)

Inspection after Removal
Check the regulator assembly for the following. If a problem is detected, grease or replace it as shown.





- Grease application points for each sliding part





- Wire wear
- Regulator deformation

Installation
Installation is in the reverse order of removal.