Removal And Installation

SHIFT CONTROL SYSTEM


A/T Shift Selector Removal and Installation


A/T SHIFT SELECTOR COMPONENTS











CONTROL CABLE COMPONENTS











REMOVAL

CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Place the selector lever in the "N" position.
2. Remove the center console assembly. Component Parts.





3. Disconnect the A/T shift selector harness connector (1).
4. Remove the key interlock cable from the A/T shift selector assembly. Service and Repair.





5. Remove the bolts (A) from the A/T shift selector assembly (1).
6. Remove exhaust front tube, center muffler and heat plates. Removal And Installation.





7. Remove the plate (1) from the A/T shift selector assembly.

Arrow Indicates Vehicle front





8. Remove the lock plate (1) from the control cable (2).

Arrow Indicates Vehicle front

9. Remove the control cable (2) from the A/T shift selector assembly.





10. Insert suitable tool at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the A/T shift selector assembly to remove the A/T shift selector assembly from the underside of the vehicle.

Arrow Indicates Vehicle front

INSTALLATION
Installation is in the reverse order of removal.





- When installing the control cable (1) to the A/T shift selector assembly (2), make sure that the control cable (1) is fully pressed in with the ribbed surface (A) facing downward from the vehicle.

Arrow Indicates Vehicle front

- After installation is completed, adjust and check the A/T position. Adjustments and Testing and Inspection.