Removal and Installation
REAR DOOR GLASS AND REGULATOR
Removal and Installation
DOOR GLASS
Removal
1. Remove the rear door finisher. Service and Repair.
2. Disconnect the harness connector of rear door speaker.
3. Position the sealing screen aside.
NOTE:
If the sealing screen is reused, cut the butyl-tape so that a part of the butyl-tape remains on the sealing screen.
4. Remove partition sash bolt and screw, pull the partition sash downward and tilt the upper end of the sash forward to pull out the sash upward.
5. Pull out the partition glass in the direction as shown.
6. Raise or lower until lower glass bolts can be seen.
- For power windows, temporarily reconnect the power window switch to operate the windows.
- For manual windows temporarily reinstall window crank handle to operate the window.
7. Remove the rear door glass bolts.
8. Pull out the rear door glass toward the outside of the door to remove.
9. Remove the door glass run from the door panel.
Installation
Installation is in the reverse order of removal.
REGULATOR ASSEMBLY
Removal
1. Remove and position aside the rear door finisher. Service and Repair.
2. Disconnect the harness connector of rear speaker.
3. Position aside the sealing screen.
4. Raise or lower until lower glass bolts can be seen.
- For power windows, temporarily reconnect the power window switch to operate the windows.
- For manual windows temporarily reinstall window crank handle to operate the window.
5. Remove the rear door glass bolts.
6. Raise up the door glass and hold with a suction lifter A.
7. Remove the regulator bolts, and then remove the regulator assembly from the door panel.
Installation
Installation is in the reverse order of removal.
Inspection after Removal
Check the regulator assembly for the following. [If a problem is detected, grease or replace it as shown].
- Gear wear
- Regulator deformation
- Grease condition for each sliding part