Component Inspection

TR SW, OD SW AND CLOSED THROTTLE, WIDE OPEN THROTTLE POSITION SIGNAL CIRCUIT


Component Inspection


OVERDRIVE CONTROL SWITCH





- Check continuity between A/T shift selector harness connector terminals.






TRANSMISSION RANGE SWITCH





1. Check continuity between transmission range switch harness connector terminals.










2. If NG, check again with control cable (2) disconnected from manual shaft (3) of A/T assembly. Refer to step 1.
(1): Lock nut
3. If OK on step 2, adjust control cable (2). Adjustments.
4. If NG on step 2, remove transmission range switch from A/T assembly and check continuity of transmission range switch terminals. Refer to step 1.
5. If OK on step 4, adjust transmission range switch. Service and Repair.
6. If NG on step 4, replace transmission range switch. Service and Repair.