Engine Cannot Be Started In "P" And "N" Position

TROUBLE DIAGNOSIS FOR SYMPTOMS


Engine Cannot Be Started in "P" and "N" Position


SYMPTOM:
- Engine cannot be started with selector lever in "P" or "N" position.
- Engine can be started with selector lever in "D", "2", "1" or "R" position.

DIAGNOSTIC PROCEDURE
1.CHECK TRANSMISSION RANGE SWITCH





Check continuity between transmission range switch harness connector terminals. AT .





OK or NG
OK - GO TO 3.
NG - GO TO 2.
2.CHECK TRANSMISSION RANGE SWITCH
Check transmission range switch again with control cable disconnected from manual shaft of A/T assembly. Refer to test group 1.
OK or NG
OK - Adjust A/T position. Adjustments .
NG - 1. Check transmission range switch (Refer to test group 1.) again after adjusting transmission range switch ( Service and Repair ).
- If OK, INSPECTION END
- If NG, repair or replace transmission range switch. Service and Repair .
3.CHECK STARTING SYSTEM
Check starting system. Description and Operation .
OK or NG
OK - INSPECTION END
NG - Repair or replace damaged parts.