Removal and Installation
FRONT DOOR GLASS AND REGULATOR
Removal and Installation
DOOR GLASS
Removal
1. Remove the front door finisher. Service and Repair.
2. Disconnect the front door speaker electrical connector.
3. Position the sealing screen aside.
NOTE:
If sealing the screen is reused, cut the butyl-tape so that a part of butyl-tape remains on the sealing screen.
4. Raise or lower the window until the glass bolts can be seen.
- For power windows, temporarily reconnect the power window switch to operate the window.
- For manual windows, temporarily reinstall the window crank handle to operate the window.
5. Remove the door glass bolts.
6. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the inside of the door.
7. Remove the lower sash (rear) bolt, move the lower end portion ahead of the door panel.(3) and pull out the insertion (2) of the upper end from the door panel to remove the lower sash
(rear)(1).
8. Remove the lower sash (front) bolt and pull out the lower sash (front) just downward to remove it.
9. Remove the door glass run from the door panel.
Installation
Installation is in the reverse order of removal.
REGULATOR ASSEMBLY
Removal
1. Remove the front door finisher. Service and Repair.
2. Disconnect the harness connector of front speaker, and then remove sealing screen.
NOTE:
If sealing screen is reused, cut the butyl-tape so that a part of butyl-tape remains on the sealing screen.
3. Raise or lower the window until the glass bolts can be seen.
- For power windows, temporarily reconnect the power window switch to operate the window.
- For manual windows, temporarily reinstall the window crank handle to operate the window.
4. Remove the window bolts.
5. Raise the door glass and hold with a suction lifter A.
6. If equipped, disconnect the harness connector from the regulator assembly.
7. Remove the regulator assembly bolts, and then remove the regulator assembly.
Installation
Installation is in the reverse order of removal.
Inspection after Removal
Check the regulator assembly for the following. [If a problem is detected, grease or replace it as shown].
- Wire wear
- Regulator deformation
- Grease condition for each sliding part