Removal And Installation Coupe

BACK DOOR


BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
- Operate with 2 workers, because of its heavy weight.
- Use protective tape or shop cloth to protect from damage during removal and installation.

REMOVAL
1. Remove back door finisher upper. Removal And Installation Coupe.
2. Remove luggage side finisher upper (LH/RH). Removal And Installation Coupe.
3. Remove rear pillar finisher (LH/RH). Coupe.
4. Remove clips of headlining at rear end. Removal And Installation Coupe.
5. Disconnect back door harness connectors (A) at body side.






Arrow Indicates Vehicle Front

6. Back door, and then pull harness out of vehicle at roof panel hole.
7. Support back door lock with the suitable material to prevent it from falling.

WARNING:
Bodily injury may occur if no supporting rod is holding the back door open when removing the back door stay.
8. Remove back door stay (LH/RH). Removal And Installation Coupe.
9. Remove back door hinge (LH/RH) mounting nuts on back door and remove back door assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check back door hinge rotating part for poor lubrication. If necessary, apply body grease.
- After installation, check back door open/close, lock/unlock operation.
- After installation, perform the fitting adjustment. Coupe.