Removal And Installation

CENTER CONSOLE ASSEMBLY


Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL
1. Remove shift knob (M/T models). Removal And Installation.
2. Remove console finisher assembly.










- A/T models
- Insert remover tool (A) between console finisher (1) and center console, lift up console finisher, and then disengage metal clips and pawls.
- Disconnect harness connectors.
- M/T models
- Pull up console finisher (2), and then disengage metal clips and pawls.
- Disconnect harness connector.

Broken Triangle Indicates Pawl
Broken Square Indicates Metal Clip

3. Remove console panel LH.





1. Remove console panel LH (1) fixing screws (B).
2. Pull the console panel LH crosswise.

Broken Square Indicates Metal Clip

4. Remove console panel RH.





1. Remove console panel RH (1) fixing screws (B).
2. Pull the console panel RH crosswise.

Broken Square Indicates Metal Clip






5. Remove center console fixing screws (A).





6. Disconnect console sub-harness connectors (A) and (B).





7. Remove cup holder assembly.
1. Pull up cup holder assembly (1).
2. Disconnect harness connectors.
3. Remove harness clip.

Broken Circle Indicates Pawl
Broken Square Indicates Metal Clip






8. Disconnect USB connector harness connector (A). (if equipped)





9. Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently.





10. Remove center console assembly.
1. Put seat assembly (LH/RH) to the frontmost position.
2. Remove center console fixing screws (A).
3. Put seat assembly (LH/RH) to the rearmost position.
4. Lift up center console assembly back side, and then remove center console assembly.

INSTALLATION
Install in the reverse order of removal.