Front Door Lock

DOOR LOCK


FRONT DOOR LOCK : Removal and Installation


REMOVAL
1. Remove the front door finisher. Removal And Installation.





2. Disconnect the inside handle knob cable and lock knob cable from the back side of the front door finisher.
3. Remove the front door window and front door module assembly. Removal And Installation.





4. Remove the door side grommet, and remove the door key cylinder assembly (driver side) or outside handle escutcheon (passenger side) bolt (TORX T30) from the grommet hole.





5. Disconnect door antenna and door request switch connector and remove harness clamp.
6. Disconnect the key cylinder rod.
7. Disconnect door key cylinder switch harness connector.





8. While pulling the outside handle (1), remove the door key cylinder assembly (2) (driver side) or outside handle escutcheon
(passenger side).
9. Disconnect the front door request switch harness connector.





10. While pulling the outside handle (1), slide it toward the rear of the vehicle (2) to remove the outside handle.





11. Remove the front and rear gaskets.





12. Remove the TORX bolts (T30), remove the door lock assembly.





13. Remove the TORX bolt (T30) (A) from the outside handle bracket.





14. While pulling the outside handle bracket, slide it toward the rear of the vehicle to remove it.
15. Disconnect the door lock actuator connector and remove the door lock assembly.





16. Disconnect the outside handle cable from the outside handle bracket connection.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- When installing the key cylinder rod be sure to rotate the rod holder until a click is felt.
- Do not reuse the door lock assembly Torx bolts (T30).