Removal and Installation

THERMOSTAT


Removal and Installation


REMOVAL
1. Drain engine coolant from radiator. Changing Engine Coolant.

CAUTION:
- Perform this step when engine is cold.
- Never spill engine coolant on drive belt.
2. Remove air duct (inlet). Exploded View.
3. Remove reservoir tank. Component.
4. Add paint mark, then disconnect radiator hose (lower) from water inlet. Component.
5. Remove water inlet and thermostat.
- Engine coolant will leak from cylinder block, so have a receptacle ready below.

INSTALLATION
Installation is in the reverse order of removal.

Thermostat





- Install thermostat making sure rubber ring (1) groove fits securely to thermostat flange (A).





- Install thermostat (2) into the cylinder block (1) with jiggle valve (A) facing upwards.

Water Inlet.





After installation, fix water inlet clip (A) on the oil level gauge guide
(1) positioned (B) as shown.