Removal And Installation

OIL PAN (LOWER)


Removal and Installation


REMOVAL

WARNING:
- Be careful not to burn yourself, as the engine oil is hot.
- Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
1. Drain engine oil. Draining.
2. Remove the oil pan (lower) with the following procedure.





Arrow Indicates Engine Front

a. Loosen bolts in the reverse of the order shown.


b. Insert the Tool between oil pan (upper) and oil pan (lower).

CAUTION:
- Be careful not to damage the mating surface.
- A more adhesive liquid gasket is applied compared to previous types when shipped, so it should not be forced off using a flat- bladed screwdriver, etc.






INSTALLATION
1. Install oil pan (lower) with the following procedure.
a. Use scraper to remove old liquid gasket from mating surfaces.
- Also remove the old liquid gasket from mating surface of oil pan (upper).
- Remove old liquid gasket from the bolt holes and threads.

CAUTION:
Never scratch or damage the mating surfaces when cleaning off old liquid gasket.





b. Apply a continuous bead of liquid gasket (B) with Tool to areas shown.






Use Genuine Silicone RTV Sealant or equivalent. Recommended Chemical Products And Sealants.

CAUTION:
Attaching should be done within 5 minutes after coating.










Arrow Indicates Engine Front


c. Tighten bolts in the numerical order shown.


2. Installation of the remaining components is in the reverse order of removal.

CAUTION:
Do not pour engine oil until at least 30 minutes after oil pan (lower) is installed.