Removal And Installation

CENTER CONSOLE ASSEMBLY

Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL

1.Remove shift knob (M/T models). Removal And Installation.
2.Remove console finisher assembly.










- A/T models
- Insert remover tool (A) between console finisher (1) and center console, lift up console finisher, and then disengage metal clips and pawls.
- Disconnect harness connectors.
- M/T models
- Pull up console finisher (2), and then disengage metal clips and pawls.
- Disconnect harness connector.

Broken triangle indicates : Pawl
Broken square indicates : Metal clip

3.Remove console panel LH.





1.Remove console panel LH (1) fixing screws (B).
2.Pull the console panel LH crosswise.

Broken square indicates : Metal clip

4.Remove console panel RH.





1.Remove console panel RH (1) fixing screws (B).
2.Pull the console panel RH crosswise.

Broken square indicates : Metal clip






5.Remove center console fixing screws (A).





6.Disconnect console sub-harness connectors (A) and (B).





7.Remove cup holder assembly.
1.Pull up cup holder assembly (1).
2.Disconnect harness connectors.
3.Remove harness clip.

Broken circle indicates : Clip
Broken square indicates : Metal clip






8.Disconnect USB connector harness connector (A). (if equipped)





9.Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently.





10.Remove center console assembly.
1.Put seat assembly (LH/RH) to the front most position.
2.Remove center console fixing screws (A).
3.Put seat assembly (LH/RH) to the rearmost position.
4.Lift up center console assembly back side, and then remove center console assembly.

INSTALLATION

Install in the reverse order of removal.