Removal And Installation

SOFT TOP CONTROL UNIT

Removal and Installation


REMOVAL






1.Operate soft top as shown in the figure.

CAUTION:
Storage lid and 5th bow may close due to low oil pressure.
Always support storage lid and 5th bow in the fully open position using a support block.
2.Turn ignition switch OFF.
3.Disconnect battery cable from the negative terminal. Removal And Installation.
4.Remove storage room finisher LH. Removal And Installation.





5.Disconnect soft top control unit (1) harness connector and hydraulic unit harness connectors (A).





6.Remove soft top control unit from hydraulic unit bracket.

INSTALLATION

Install in the reverse order of removal.