P0116

DTC P0116 ECT SENSOR

Component Description






The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the
ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.





[Reference data]







On Board Diagnosis Logic








DTC Confirmation Procedure


1. INSPECTION START

Is it necessary to erase permanent DTC?
YES- GO TO 3.
NO- GO TO 2.

2. PERFORM OVERALL FUNCTION CHECK

Perform overall function check. .
NOTE:
Use the overall function check to check the overall function of the ECT sensor circuit. During this check, a 1st trip DTC might not be confirmed.
Is the inspection result normal?
YES- INSPECTION END
NO- Proceed to .

3. PRECONDITIONING

If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
-Before performing the following procedure, do not add fuel.
-Before performing the following procedure, check that fuel level is between 1/4 and 4/4.
-Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.
- GO TO 4.

4. PERFORM DTC CONFIRMATION PROCEDURE

1.Start engine and let it idle for 60 minutes.
2.Move the vehicle to a cool place.
NOTE:
Cool the vehicle in an environment of ambient air temperature between 10�C (14�F) and 35�C (95�F).
3.Turn ignition switch OFF and soak the vehicle for 12 hours.

CAUTION:
Never turn ignition switch ON during soaking.
NOTE:
The vehicle must be cooled with the food open.
4.Start engine and let it idle for 5 minutes or more.

CAUTION:
Never turn ignition switch OFF during idling.
5.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- INSPECTION END


Overall Function Check


1. CHECK ENGINE COOLANT TEMPERATURE (ECT) SENSOR

1.Turn ignition switch OFF.
2.Disconnect ECT sensor harness connector.
3.Remove ECT sensor. Component.





4.Check resistance between ECT sensor terminals by heating with hot water as shown in the figure.





Is the inspection result normal?
YES- GO TO 2.
NO- Proceed to .

2. CHECK INTERMITTENT INCIDENT

Check intermittent incident. Trouble Diagnosis For Intermittent Incident.
Is the inspection result normal?
YES- INSPECTION END
NO- Proceed to .


Diagnosis Procedure


1. CHECK GROUND CONNECTIONS

1.Turn ignition switch OFF.
2.Loosen and retighten ground screw on the body.
Power Supply And Ground Circuit.










OK or NG
OK- GO TO 2.
NG- Repair or replace ground connections.

2. CHECK ENGINE COOLANT TEMPERATURE SENSOR

.
OK or NG
OK- GO TO 3.
NG- Replace engine coolant temperature sensor. Component.

3. CHECK INTERMITTENT INCIDENT

Refer to Initial Inspection and Diagnostic Overview
-INSPECTION END


Component Inspection


ENGINE COOLANT TEMPERATURE SENSOR






1.Check resistance between engine coolant temperature sensor terminals 1 and 2 as shown in the figure.





[Reference data]





2.If NG, replace engine coolant temperature sensor. Component.