P1745

P1745 LINE PRESSURE CONTROL

Description

The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.


On Board Diagnosis Logic

- This is not an OBD-II self-diagnostic item.
- Diagnostic trouble code "P1745" with CONSULT is detected when TCM detects the unexpected line pressure.


Possible Cause

TCM


DTC Confirmation Procedure

NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT

1.Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
2.Make sure that output voltage of CVT fluid temperature sensor is within the range below.

ATF TEMP SEN: 1.0 - 2.0 V
If out of range, drive the vehicle to decrease the voltage (warm up the fluid) or stop engine to increase the voltage (cool down the fluid)

3.If DTC is detected, go to .


Diagnosis Procedure


1. CHECK DTC

1.Turn ignition switch ON. (Do not start engine.)
2.Select "SELF-DIAG RESULTS" mode for "TRANSMISSION" with CONSULT.
3.Erase self-diagnostic results. Reading and Clearing Diagnostic Trouble Codes.
4.Turn ignition switch OFF, and wait for 10 seconds or more.
5.Start engine.
6.Confirm self-diagnostic results again. Trouble Diagnosis .
Is the "P1745" displayed?
YES- Replace TCM. Service and Repair .
NO-INSPECTION END