Operation CHARM: Car repair manuals for everyone.

Inspection after Installation




FRONT DOOR GLASS AND REGULATOR

Inspection after Installation


POWER WINDOW SYSTEM INITIALIZATION

Initialize power window system Refer to:Programming and Relearning

INSPECT THE FUNCTION OF THE ANTI-PINCH SYSTEM

1.Fully open the door glass.
2.Place a wooden piece (wooden hammer handle, etc.) near the fully closed position.
3.Carry out fully closing operation with auto up switch.
- Check that the glass reverses without pinching the wooden piece, is lowered approx.150 mm (5.91 in) or for
2 seconds and then stops.
- The glass should not be raised with power window main switch while it is reversing or lowering.

CAUTION:
- Use care to avoid being pinched during the inspection. Do not use a hand, etc. in place of the wooden piece during the inspection.
- Check that auto up function is normal before inspection, following the system initialization.

FITTING INSPECTION

- Make sure the glass is securely fit into the glass run groove.
- Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and make sure the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and the glass and guide rail bolts to correct the glass position.
- Make sure the system is normal with raising and lowering the glass.