Removal and Installation

FRONT DOOR GLASS AND REGULATOR

Removal and Installation












DOOR GLASS

Removal
1.Remove the front door finisher. Service and Repair.
2.Disconnect the front door speaker harness connector.
3.Position aside vapor barrier.
NOTE:
If the vapor barrier is reused, cut the butyl-tape so that a part of butyl-tape remains on the vapor barrier.





4.Temporarily reconnect the power window switch to operate the window.
5.Raise or lower the window until the glass bolts can be seen.
6.Remove the door glass bolts.





7.While holding the door window, raise it at the rear end to pull the glass out of the sash toward the inside of the door.
8.Remove the lower sash (rear) bolt, move the lower end portion ahead of the door panel.(3) and pull out the insertion (2) of the upper end from the door panel to remove the lower sash (rear)(1).





9.Remove the lower sash (front) bolt and pull out the lower sash (front) just downward to remove it.
10.Remove the door glass run from the door panel.
Installation
Installation is in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1.Remove the front door finisher. Service and Repair.
2.Disconnect the harness connector for the front speaker
3.Position aside the vapor barrier.
NOTE:
If vapor barrier is reused, cut the butyl-tape so that a part of butyl-tape remains on the vapor barrier.





4.Temporarily reconnect the power window switch to operate the window.
5.Raise or lower the window until the glass bolts can be seen.
6.Remove the door glass bolts.





7.Raise the door glass and hold with a suction lifter A.
8.Disconnect the harness connector from the regulator assembly.





9.Remove the regulator assembly bolts, and then remove the regulator assembly.
Installation
Installation is in the reverse order of removal.
Inspection after Removal





Check the regulator assembly for the following. [If a problem is detected, grease or replace it as shown].
- Wire wear
- Regulator deformation
- Grease condition for each sliding part