P0711

P0711 TRANSMISSION FLUID TEMPERATURE SENSOR A

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Start the engine.
2.Drive the vehicle.
3.Maintain the following conditions for a total of 10 minutes or more.





4.Stop the vehicle.
5.Check the first trip DTC.
Is "P0711" detected?
YES- Go to P0743.
NO- INSPECTION END


Diagnosis Procedure


1. CHECK CVT FLUID TEMPERATURE SENSOR

1.Turn ignition switch OFF.
2.Disconnect CVT unit connector.
3.Check CVT fluid temperature sensor. .
Is the inspection result normal?
YES- Check intermittent incident. Intermittent Incident.
NO- Repair or replace malfunctioning parts.


Component Inspection (CVT Fluid Temperature Sensor)


1. CHECK CVT FLUID TEMPERATURE SENSOR

Check resistance between CVT unit connector terminals.





Is the inspection result normal?
YES- INSPECTION END
NO- There is a malfunction of CVT fluid temperature sensor. Replace transaxle assembly. Refer to
Removal And Installation.