Fuel Injector

FUEL INJECTOR

Component Function Check


1. INSPECTION START

Turn ignition switch to START.
Is any cylinder ignited?
YES- GO TO 2.
NO- Go to .

2. CHECK FUEL INJECTOR FUNCTION

With CONSULT
1.Start engine.
2.Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
3.Make sure that each circuit produces a momentary engine speed drop.
Without CONSULT
1.Let engine idle.





2.Listen to each fuel injector operating sound.
Clicking noise should be heard.
Is the inspection result normal?
YES- INSPECTION END
NO- Go to .


Diagnosis Procedure


1. CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect fuel injector harness connector.
3.Turn ignition switch ON.
4.Check the voltage between fuel injector harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. DETECT MALFUNCTIONING PART

Check the following.
- IPDM E/R connector F42
- 10 A fuse (No. 55)
- Harness for open or short between fuel injector and fuse
- Repair open circuit or short to ground or short to power in harness or connectors.

3. CHECK FUEL INJECTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between fuel injector harness connector and ECM harness connector.





4.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair open circuit or short to ground or short to power in harness or connectors.

4. CHECK FUEL INJECTOR

.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace malfunctioning fuel injector. Removal And Installation

5. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
Is the inspection result normal?
YES- Replace IPDM E/R. Service and Repair.
NO- Repair or replace harness or connectors.


Component Inspection


1. CHECK FUEL INJECTOR

1.Turn ignition switch OFF.
2.Disconnect fuel injector harness connector.
3.Check resistance between fuel injector terminals as follows.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace malfunctioning fuel injector. Removal And Installation.