Removal And Installation

FRONT BUMPER

Removal and Installation


REMOVAL






1.Remove the core support cover clips (A), then remove the core support (1).
2.Partially remove the front fender protectors (LH/RH). Refer to "FENDER PROTECTOR : Removal and Installation" Removal And Installation.
3.Remove the front under cover. Refer to "Removal and Installation" Removal And Installation.
4.Remove the hood ledge finisher.





5.Remove the front bumper fascia to upper fender screws (A) (LH/
RH), then rotate clockwise each front bumper fascia upper side bracket (1) to remove.





6.Remove the front bumper fascia to fender screw (A) (LH/RH).
7.Disconnect the harness connectors from front fog lamps (LH/RH) (if equipped).
8.Disconnect the harness connectors from turn signal and hazard warning lamps (LH/RH).
9.Release the front bumper fascia from the front bumper fascia side brackets (LH/RH).





10.Remove the front bumper fascia by releasing in the order shown.

CAUTION:
When removing front bumper fascia, two people are required to avoid damaging.
11.Remove the front energy absorber.





12.Remove the front bumper reinforcement bracket bolts (A) and the front bumper reinforcement bracket (1).
13.Remove the front bumper reinforcement nuts, then the front bumper reinforcement.
14.Remove the front bumper support bolts, then the front bumper reinforcement supports (LH/RH).
15.Remove the following parts after removing front bumper fascia.
- Front grille
- Front bumper fascia (LH/RH) finisher (if equipped)
- Tow cover
- Turn signal and hazard warning lamps (LH/RH). Refer to "Removal and Installation" Removal And Installation.
- Front fog lamp finishers (LH/RH) (if equipped)
- Front fog lamp assemblies (LH/RH) (if equipped)
- Front bumper fascia side brackets (LH/RH)
- Front license plate bracket (if equipped)

INSTALLATION

Installation is in the reverse order of removal.
- Adjust fog lamp aiming (if equipped). Refer to "Aiming Adjustment" Adjustments.





mm (in)