Inspection

RADIATOR

Inspection


INSPECTION AFTER INSTALLATION

- Check that the reservoir tank cap is tightened.





- Check for leakage of engine coolant using Tool (B) and suitable tool (A). Refer to "System Inspection" Initial Inspection and Diagnostic Overview.

Tool number: EG17650301 (J-33984-A)

Testing pressure : 156 kPa (1.6 kg/cm2, 23 psi)

WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator.

CAUTION:
Higher pressure than specified may cause radiator damage.
- Start and warm up the engine. Visually check that there is no leakage of engine coolant and CVT fluid.