Meter Control Switch Signal Circuit

METER CONTROL SWITCH SIGNAL CIRCUIT

Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.

1. CHECK METER CONTROL SWITCH SIGNAL

1.Turn ignition switch ON.
2.Check voltage between the following terminals of the meter control switch harness connector M158.





Is the inspection result normal?
YES- Inspection End.
NO- GO TO 2.

2. CHECK METER CONTROL SWITCH HARNESS

1.Turn ignition switch OFF.
2.Disconnect combination meter harness connector M26 and meter control switch harness connector
M158.
3.Check continuity between combination meter harness connector M26 and meter control switch harness connector M158.





4.Check continuity between combination meter harness connector and ground.





Is the inspection result normal?
YES- Inspection End.
NO- Repair or replace harness or connectors.


Component Inspection


1. CHECK METER CONTROL SWITCH

1.Turn ignition switch OFF.
2.Disconnect meter control switch connector.
3.Check meter control switch.





Is the inspection result normal?
YES- Inspection End.
NO- Replace meter control switch. Refer to "Exploded View" Exploded View.