Rear Door Window Glass: Service and Repair

REAR DOOR GLASS

Removal and Installation


REMOVAL

1.Remove the rear door finisher. Refer to "Removal and Installation" Removal And Installation.
2.Remove the vapor barrier.

CAUTION:
Use care to not damage or tear vapor barrier during removal.
3.Remove the rear door window inside seal.
4.Remove the rear door window run rubber.





5.Remove bolts (A) and rear door glass rear run channel (1).





6.Temporarily reconnect the rear power window switch to raise/
lower the rear door glass until the rear door regulator to glass bolts (A) can be seen through the access holes.
7.Remove the rear door glass to regulator bolts (A).

CAUTION:
When removing the door regulator to glass bolts be sure to secure glass to prevent it from falling.
8.Remove the door glass.

INSTALLATION

Installation is in the reverse order of removal.
- After installation inspect and adjust as necessary.
- Tighten the rear door regulator to glass bolts to specification.
Rear door regulator to glass bolts: 7.0 Nm (0.7 kg-m, 62 in-lb)

REAR DOOR GLASS INSPECTION AFTER INSTALLATION

- Check that the door glass is securely set into the glass run groove.
- Lower the glass slightly [approx. 10 to 20 mm (0.4 to 0.8 in)], and make sure the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.