Removal And Installation - Seatback Board

FRONT SEAT

DRIVER SIDE : Removal and Installation - Seatback Board


REMOVAL


CAUTION:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Always work from the side or back of the seatback assembly, do not work in front of seat.
1.Slide the seat to the full forward position.
2.Disconnect the negative and positive battery terminals and wait a least three minutes. Refer to "Removal and Installation (Battery)" Removal And Installation.





3.Remove the seatback board (1).
NOTE:
The back side of the seatback board is shown to assist with identifying fastener location.
a.Release the two bottom clips (A) using a suitable tool.
Broken triangle indicates : Clip

b.Insert fingers into sides (black arrow) and pull out the seatback board, while pressing the side clips (B) to release it from the seatback frame.
c.Pull the seatback board down releasing the upper hooks (C) and remove.

INSTALLATION

Installation is in the reverse order of removal.