Removal And Installation

SPARK PLUG

Removal and Installation


REMOVAL

1.Remove the ignition coil. Refer to "Removal and Installation LH" LH (LH side) and "Removal and Installation RH" RH (RH side).
2.Remove the spark plug using suitable tool.






INSPECTION AFTER REMOVAL






- Do not use a wire brush for cleaning the spark plugs. Replace as necessary.
- If plug is covered with carbon, a spark plug cleaner may be used.

Cleaner air pressure : less than 588 kPa (6 kg/cm2, 85 psi)
Cleaning time : less than 20 seconds





- Checking and adjusting plug gap is not required between change intervals. If the gap is out of specification, replace the spark plug.

INSTALLATION

Installation is in the reverse order of removal.