Diagnosis Procedure (For Canada)

REMOTE KEYLESS ENTRY RECEIVER

Diagnosis Procedure (For Canada)

Regarding Wiring Diagram information, refer to "Wiring Diagram" Electrical Diagrams.

1. CHECK REMOTE KEYLESS ENTRY RECEIVER OUTPUT SIGNAL

1.Turn ignition switch OFF.
2.Check signal between remote keyless entry receiver connector and ground with oscilloscope.





Is the inspection result normal?
YES- GO TO 7
NO- GO TO 2

2. CHECK REMOTE KEYLESS ENTRY RECEIVER POWER SUPPLY

1.Disconnect remote keyless entry receiver connector.
2.Check signal between remote keyless entry receiver connector and ground with oscilloscope.





Is the inspection result normal?
YES- GO TO 4
NO- GO TO 3

3. CHECK REMOTE KEYLESS ENTRY RECEIVER CIRCUIT 1

1.Disconnect BCM connector.
2.Check continuity between BCM connector and remote keyless entry receiver connector.





3.Check continuity between BCM connector and ground.





Is the inspection result normal?
YES- Reconnect BCM, GO TO 4
NO- Repair or replace harness between BCM and remote keyless entry receiver.

4. CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT

Check continuity between remote keyless entry receiver connector and ground.





Is the inspection result normal?
YES- GO TO 6
NO- GO TO 5

5. CHECK REMOTE KEYLESS ENTRY RECEIVER CIRCUIT 2

Check continuity between BCM connector and remote keyless entry receiver connector.





Is the inspection result normal?
YES- GO TO 6
NO- Repair or replace harness between BCM and remote keyless entry receiver.

6. CHECK REMOTE KEYLESS ENTRY RECEIVER CIRCUIT 3

1.Check continuity between BCM connector and remote keyless entry receiver connector.





2.Check continuity between BCM connector and ground.





Is the inspection result normal?
YES- GO TO 7
NO- Repair or replace harness between BCM and remote keyless entry.

7. CHECK REMOTE KEYLESS ENTRY RECEIVER RSSI SIGNAL CIRCUIT

1.Disconnect BCM connector.
2.Check continuity between BCM harness connector and remote keyless entry receiver harness connector.





3.Check continuity between BCM harness connector and ground.





Is the inspection result normal?
YES- GO TO 8
NO- Repair or replace harness between BCM and remote keyless entry.

8. CHECK REMOTE KEYLESS ENTRY RECEIVER RSSI SIGNAL

1.Reconnect remote keyless entry receiver connector.
2.Check signal between remote keyless entry receiver harness connector and ground using oscilloscope.





Is the inspection result normal?
YES- GO TO 9.
NO- Replace remote keyless entry receiver. Refer to "Removal and Installation" With Intelligent Key System.

9. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- Inspection End.