Removal and Installation

GENERATOR

Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal. Refer to "Removal and Installation" Removal and Replacement.
2.Remove fender protector (RH). Refer to "Removal and Installation" Removal And Installation.
3.Remove the under cover. Refer to "Removal and Installation" Removal And Installation.
4.Remove drive belt. Refer to "Removal and Installation" Service and Repair.
5.Remove the horn bracket.
6.Disconnect generator harness connector.
7.Remove "B" terminal nut and disconnect "B" terminal harness.
8.Remove generator bolts.





9.Remove the generator.

CAUTION:
Be careful not to damage surrounding parts when removing generator from the vehicle.
NOTE:
Front fascia shown removed for clarity.
10.Remove generator bracket if necessary.

INSTALLATION






1.Install the generator bracket (if removed), using the following procedure.
a.Temporarily tighten bolt (1).
b.Temporarily tighten bolt (2).
c.Tighten bolts (3) and (4) to specification in numerical order as shown.
2.Install generator using the following procedure.
a.Temporarily tighten the generator bolts in order from the lower to the upper.
b.Tighten the generator bolts to the specification starting with the top bolt.
c.Install "B" terminal harness and "B" terminal nut.

CAUTION:
Be sure to tighten "B" terminal nut carefully.
3.Install and check the tension of the drive belt. Refer to "Removal and Installation" Service and Repair.
4.Installation of the remaining components is in the reverse order of removal.