Removal and Replacement

OIL PAN

Removal and Installation


REMOVAL

1.Remove the drain plug and overflow tube, and then drain the ATF.

WARNING:
A/T fluid can splash when draining, use safety glasses to protect eyes.
2.Remove the drain plug gasket from the drain plug.





3.Remove the oil pan bolts (black arrow), and then remove the oil pan and oil pan gasket.

White arrow indicates: Front

4.Remove the magnets from the oil pan.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Do not reuse oil pan gasket and drain plug gasket.
- Do not reuse oil pan bolts.
- Completely remove all moisture, oil, old gasket, etc. from the oil pan gasket mating surface of transaxle case and oil pan.
- When installing the overflow tube, be sure to tighten to the specified torque. If it is not tightened to the specified torque, the tube may be damaged.





- When the oil pan is installed, temporarily tighten oil pan bolts, then tighten the oil pan bolts to specification in the order shown.

White arrow indicates: Front