Removal And Installation Procedure For A/T Assembly Connector

PRECAUTIONS

Removal and Installation Procedure for A/T Assembly Connector


REMOVAL






Rotate bayonet ring (A) counterclockwise. Pull out A/T assembly harness connector (B) upward and remove it.

INSTALLATION






1.Align marking (A) on A/T assembly harness connector terminal body with marking (B) on bayonet ring. Insert A/T assembly harness connector. Then rotate bayonet ring clockwise.





2.Rotate bayonet ring clockwise until marking (A) on A/T assembly harness connector terminal body is aligned with the slit (B) on bayonet ring as shown in the figure (correctly fitting condition).
Install A/T assembly harness connector to A/T assembly harness connector terminal body.

CAUTION:





- Securely align marking (A) on A/T assembly harness connector terminal body with bayonet ring slit (B). Then, be careful not to make a half fit condition as shown in the figure.

- Do not mistake the slit of bayonet ring for other dent portion.