Removal and Installation

CONTROL CABLE

Removal and Installation


CAUTION:
Always apply the parking brake before performing removal and installation.

REMOVAL

1.Remove the battery. Refer to "Removal and Installation" Removal and Replacement.
2.Remove the TCM and bracket. Refer to "Removal and Installation" Removal And Installation.
3.Remove the IPDM E/R. Refer to "Removal and Installation" IPDM E/R (Without I-Key).
4.Remove the center console. Refer to "Removal and Installation" Removal And Installation.
5.Remove the control cable from the shift selector assembly.





6.Disengage the pawls (B) of the grommet (A), and pull downwards to remove.
7.Remove the control cable nut from the manual lever.





8.Remove the lock plate (1).





9.Lift up the heat plate.
10.Remove the control cable (1) from the bracket (2).

White arrow indicates: Front

11.Remove the control cable from the vehicle.
12.Remove bracket.

INSTALLATION

Installation is in the reverse order of removal.





- From below the vehicle, press the grommet (A) into place until the pawls (B) make a click sound.

CAUTION:
Check that pulling down on the grommet does not disconnect it.
- Pay attention to the following when connecting the control cable to the shift selector.





1.When connecting the control cable (1) to the shift selector assembly (2), face the grooved surface of the rib (A) up and insert the control cable until it stops.





2.Install the socket (A) onto the shift selector assembly.

CAUTION:
- Insert the socket into the shift selector assembly, then push it firmly in place.
- Check that pulling on the socket does not disconnect it.