Line Pressure Test

LINE PRESSURE TEST

Inspection and Judgment


INSPECTION

1.Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to "Inspection" Inspection.
2.Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is to 50 to 80�C (122
to 176�F).
3.Inspect the amount of ATF. Replenish if necessary. Refer to "Inspection" Inspection.
4.Remove fluid pressure detection plug.










5.Install the joint pipe adapter [SST: KV31103600 (-)], adapter [SST: 25054000 (J-25695-4)], and oil pressure gauge set (commercial service tool).
NOTE:
When using oil pressure gauge, be sure to use O-ring attached to fluid pressure detection plug.
6.Securely engage parking brake so that the tires do not turn.
7.Start the engine.
8.Measure the line pressure at both idle and the stall speed.

CAUTION:
Keep brake pedal pressed all the way down during measurement.

Line pressure: "Line Pressure" Pressure, Vacuum and Temperature Specifications
9.Install O-rig to fluid pressure detection plug.

CAUTION:
- Never reuse O-ring.
- Apply ATF to O-ring.
10.Install fluid pressure detection plug.






JUDGMENT