Scan Tool Testing and Procedures

DIAGNOSIS SYSTEM (TCM)

CONSULT Function (TRANSMISSION)


CONSULT APPLICATION ITEMS











*: Although "Function Test" and "Special Function" are selectable, do not use its.

WORK SUPPORT

Display Items List






SELF DIAGNOSTIC RESULTS

Refer to "DTC Index" Testing and Inspection.
DTC at 1st trip and method to read DTC
- DTC (P0705, P0711, P0720, etc.) is specified by SAE J2012/ISO 15031-6.
- DTC and DTC at 1st trip are displayed on "Self Diagnostic results" of CONSULT. " Timing" shows current malfunction or malfunction in the past.
If current DTC is detected, "timing" is "present". If the "timing" is "memorized", it is the malfunction occurred in the past. According to "ignition counter" in "FFD", the number (trip) of operation without malfunction of the
DTC can be checked.
- When the DTC at the 1st trip is detected, the "timing" is displayed as "1t".
DTC deletion method
NOTE:
If the ignition switch is left ON after repair, turn OFF the ignition switch and wait for 10 seconds or more. Then, turn ignition ON again. (Engine stop)
1.Touch "TRANSMISSION" of CONSULT.
2.Touch "Self Diagnostic Result".
3.Touch "Erase". (DTC memorized in TCM is erased.)
IGN counter
The ignition counter is displayed in "FFD" and the number of times of satisfied "Driving Pattern A" is displayed after normal recovery of DTC. Refer to "DIAGNOSIS DESCRIPTION : Counter System" Counter System.
- If malfunction (DTC) is currently detected, "0" is displayed.
- After normal recovery, every time "Driving Pattern A" is satisfied, the display value increases from 1 --> 2 --> 3...38 --> 39.
- When MIL turns OFF due to the malfunction and the counter reaches 40, the DTC is erased.
NOTE:
The counter display of "40" cannot be checked.

DATA MONITOR

Display Items List
X: Standard, -: Not applicable, : Option





















DTC & SRT CONFIRMATION

DTC Work Support