Console Replacement - Overhead (Dual)

Console Replacement - Overhead (Dual)

Removal Procedure





1. Insert a small, flat-bladed tool between the interior lamp/multifunction switch/reading lamp housing and the overhead console.
2. Press inward and down in order to release the interior lamp/multifunction switch/reading lamp housing from the overhead console.




3. Remove the interior lamp/multifunction switch/reading lamp housing from the overhead console.
4. Disconnect the electrical connectors from the interior lamp/multifunction switch.




5. Remove the screw from the front of the overhead console.
6. Open the rear storage compartment in the overhead console in order to access the rear screws.
7. Remove the screws from the rear of the front overhead console.
8. Remove the overhead console from the headliner.
9. Remove the driver information center. Refer to Driver Information Center Replacement in Instrument Panel, Gauges and Console.



Installation Procedure

1. Install the driver information center. Refer to Driver Information Center Replacement in Instrument Panel, Gages and Console.




2. Align the overhead console to the headliner.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the screw to the front of the overhead console.

Tighten the screw to 2 N.m (18 lb in).

4. Open the rear storage compartment in the overhead console in order to access the holes for the rear mounting screws.
5. Install the screws to the rear of the overhead console.

Tighten the screw to 2 N.m (18 lb in).





6. Connect the electrical connectors to the interior lamp/multifunction switch.
7. Align the retaining tabs on the interior lamp/multifunction switch/reading lamp housing with the overhead console.
8. Press up on the interior lamp/multifunction switch/reading lamp housing in order to install the housing into the overhead console.